2020 BMW X3 recalls

I am reporting a safety concern involving BMW vehicles equipped with the B58 Technical Update (B58TU) engine, commonly found in model years 2019–2021. These vehicles utilize a variable-displacement engine oil pump containing an internal thermoplastic adjusting component responsible for regulating oil pressure. Field failures are increasingly being reported in which this internal component fractures, resulting in sudden loss or instability of engine oil pressure. The failure frequently occurs during cold-start operation in low ambient temperatures. When the component fails, oil pressure regulation becomes erratic or is lost entirely. In many cases, drivers receive little or no actionable warn

I am reporting a chronic manufacturing defect on my 2020 BMW X3 that poses an immediate electrical short-circuit and vehicle safety hazard. The passenger-side panoramic sunroof drainage system/roof structure leaks water heavily through the side panel joint of the door frame, directly saturating the front passenger floor carpet. This issue has been ongoing since I received the vehicle in 2020.The vehicle has been brought to Kelly BMW of Columbus, Ohio, at least four separate times since 2020 specifically to address this leak. Technicians have replaced outer seals and cleared tracks, but the leak persists, and on the last visit, unqualified dealership staff claimed they "could not find anythin

The contact owns a 2020 BMW X3. The contact stated that while driving 25 MPH, the message “Heat Management Module Malfunction” was displayed and the warning light was illuminated. The drive-train warning light was illuminated. Upon research, the contact became aware of NHTSA Campaign Number: 21V586000 (Fuel System, Diesel). The vehicle was previously taken to the dealer to be diagnosed, and the contact was informed that the high-pressure fuel pump needed to be replaced. The vehicle was repaired, but the failure reoccurred. The manufacturer was contacted, but no additional assistance was provided due to a prior good-faith repair being provided. The failure mileage was approximately 70,000.

Heat Management Module HMM is bad. BMW used a plastic part that is right up against the engine block. This HMM Heat Management Module resulted in STOPPING the vehicle completely in the middle of the freeway. I had no control. Then the car drove, then stopped again. I had NO CONTROL over the vehicle. Weeks later the Drivetrain Malfunction warning light appeared as i was driving home late at night from the ER. I took it to my BMW dealer. The diagnostic test was performed and was told the Heat Management Module HMM needed to be replaced at a cost to me of $3000. I contacted BMW USA, explained what transpired and they responded with a denial. I stopped driving the car completely after i found ot

I own a 2020 BMW X3 M40i, VIN [XXX], manufactured November 2019, now at approximately 100,000 miles, equipped with the B58TU engine. My oil level sensor stopped completing measurements at approximately 45,000 miles, a known precursor to thermoplastic oil pump failure. For 55,000 miles I had no way to identify whether my vehicle contained the defective component because BMW removed the original thermoplastic part number from all dealer networks. VIN-based lookup now falsely returns updated metal component information regardless of what is physically present in the vehicle. This makes proactive identification impossible for both owners and dealers, meaning the defect cannot be remediated even