2020 Chevrolet Traverse recalls

The contact owns a 2020 Chevrolet Traverse. The contact stated that while driving 30 MPH through an intersection with a green traffic light, the transmission unexpectedly stopped functioning, and the vehicle failed to move. The contact stated that the hazard lights were activated while the vehicle was in traffic. The vehicle was towed to a service center, where the failure was addressed; however, the vehicle was not diagnosed or repaired. The failure mileage was approximately 157,000.

The contact owns a 2020 Chevrolet Traverse. The contact stated that the check engine warning light was illuminated. The vehicle was taken to an independent mechanic, where it was diagnosed with a fractured flex pipe. The mechanic informed the contact that the failure was associated with GM Technical Service Bulletin: PIP 5681C and Manufacturer Communication Number: 10211780 (Engine and Engine Cooling), and the contact was referred to the dealer. The vehicle was taken to the dealer, who confirmed the failure was not covered under warranty. The contact spoke with the manufacturer, who also confirmed that the vehicle was not covered under warranty. The manufacturer referred the contact to the N

Shift to park message error. Have to start/ stop engine several times until message goes away

Noticed rattling under front hood and exhaust entering the interior of the car. Brought to the dealer and they said there are no recalls on this problem and quoted 4K to replace the CAT and exhaust pipes. There is indeed a tsb document covering Chevy Traverse years 2018-2023 - PIP5681C failed bracket weld on the exhaust pipe causes cracks. This is a dangerous situation with exhaust entering the vehicle. I have 4 children that travel in that vehicle daily! Based on what I have read online, this is an existing problem happening frequently with Chevy Traverses. I would like this repair covered by GM. [XXX] [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 55

I was on the interstate trying to merge into traffic and I floored the gas pedal to get into position with the flow of traffic. Upon pushing the gas pedal to its full position the pedal snapped off and I lost my ability to accelerate. I was lucky enough to be able to pull off to the side of the interstate and into the grass. I placed the Traverse into neutral and came to a stop. The gas pedal snapped just above the tab that sticks out where it connects to the module. Very unsafe that this is even a possibility to have happened. I would not recommend plastic for the gas pedal. Thank God the brake pedal is metal.