2021 Ram 2500 recalls

The contact owns a 2021 Ram Promaster 2500. The contact received notification of NHTSA Campaign Number: 25V552000 (Back Over Prevention); however, the part to do the recall repair was not yet available. The contact stated that while reversing, the rear-view camera was inoperable. The dealer was contacted and informed the contact that only three parts could be ordered monthly, and the contact was placed on a waiting list. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The failure mileage was approximately 70,000.

ABS/Forward Collision/Traction Control/4WD/Cruise Control warning lights on. Braking is inconsistent. Sometimes hard to brake, sometimes brake pedal is real spongy and will go almost to floor.

I am writing to formally follow up regarding complaint/case number 97989810 through Dodge and to request that this matter be elevated for a complete technical review concerning my 2021 Ram 2500 6.7L Cummins, VIN [XXX]. Time - Line PRIOR FACTORY-WARRANTY REPAIR The XXX factory-warranty repair is an important part of this vehicle's mechanical history. That repair involved the timing-cover/timing-gear-case area and front crankshaft seal. As part of that repair, the harmonic balancer/vibration damper was removed and reinstalled. Approximately 26,000 miles later, the vehicle experienced a failure involving the vibration damper and its associated mounting bolts. +++ Vehicle receipt will be attache

There is a known issue with the Ram Power Wagon locking differential system where the electronic locking differential wiring harness will fault one of three ways. The first being that the wiring harness is two short so when the rear axle articulates there isn't enough slack therefore causing the plug in the diff housing to fail. The second is that sensor inside the housing faults due to gear oil build up on the sensor. Finally the third if the locker wiring inside the housing wears out causes the locker to fault. Any of these three issues causes a "Service Axle Locker System" and prevents the front and rear lockers to be used indefinitely. This can cause the truck to become stuck during off

The contact owns a 2021 Ram ProMaster 2500. The contact received notifications of NHTSA Campaign Numbers: 25V552000 (Back Over Prevention) and 25V720000 (Engine and Engine Cooling); however, the parts to do the recall repairs were unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The vehicle was taken to the dealer, and the contact was informed that the repair might take 2 or 3 days to be completed. The dealer was only able to pay for a rental vehicle for two days. The contact stated that 5 days later, the dealer was still waiting on parts from the manufacturer to repair the vehicle. The vehicle was not repaired. The manufac